This would be perfect for a DIY guitar amp builder making a push pull tube type amplifier. The transformer could also work as a replacement in some Fender amplifiers such as Blues Deluxe and similar... However note that the screw/bolt spacing is different to the Fender one and is of slightly different orientation (see pictures). The transformer could also work in many other guitar amplifiers, but you must understand that some modifications are needed and that you take full responsibility on deciding on what those are and that we can only supply voltages as listed bellow.
Note that regardless of what drop down menu you choose the shape of the transformer is always the same and according to the specs bellow. There is still a possibility that it could have them but impossible to know so by purchasing you agree that this is not a requirement. There are no mounting bolts included in the sale however M4, M5 or M6 bolts should be suitable. The mounting holes are slightly egg shaped to allow for adjustment. It is assumed that by using this transformer you have sufficient knowledge and skill to it's application and installation.
Extreme care must be taken as very high voltages are present. Mounting of transformer will require DIY skills especially if you plan to use it as a replacement in an already existing amp. Consult the specification bellow for mounting holes spacing and diameters.
Mounting hole spacing: 65x65mm (+-2mm). Mounting hole diamter: 6x9mm (oval shaped). Wire Length (from body): 280mm (+-5mm). Green-Green 6.3VAC 3.2A.Wire used: copper wire QA-1. Yoke: EI76 thickness2.0mm, C=11.5 M4X55. Density of Varnish: JC-B46A 14-15 Seconds.
Just contact for costs as pack size weight differs so tricky to list. This item is in the category "Musical Instruments & DJ Equipment\Guitars & Basses\Parts & Accessories\Amplifier Parts". The seller is "jazzyinstruments" and is located in this country: GB. This item can be shipped to United Kingdom.