Fire-Lite FL-PS6 6.0 Amp 120 VAC Remote Charger Power Supply, Lockable & Metal Enclosure, Red (Replacement for FCPS-24S6 & HPF24S6). The PS Series is a remote power supply line from FireLite Alarms and is a direct replacement for the FCPS-24FS6/8 Series. The FLPS6(C) is a 6 amp and the FL-PS10(C) is a 10-amp, remote power supply with battery charger that may be connected to any 12- or 24-volt fire alarm control panel (FACP) or used as a standalone power supply. The PS Series provides 24 VDC power for NACs (notification appliance circuits) configured as either Class B or Class A (requires the ZNAC-PS option card) with multiple sync protocol options.
The PS Series also provides auxiliary power, constant or resettable, suited for detectors, annunciators, door holders, and other fire alarm system peripherals. The PS Series cabinet can hold two 7 AH or 18 AH batteries and can charge up to 33 AH batteries in a separate cabinet.
Up to five (6-amp model) or seven (10-amp model) independently-configurable, power-limited output circuits for. Class B and/or Class A NACs. Class B and/or Class A resettable or non-resettable 24V auxiliary power.
Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power. Configurable for ANSI® Temporal 3 or Temporal 4 coded output. UL-Listed NAC synchronization using System Sensor®, Wheelock®, Gentex®, or AMSECO® appliances.
Synchronization can be triggered from FACP NAC/remote sync outputs, cascaded power supply, or a control module, single or multi, which may be housed within the power supply cabinet. Ability to cascade up to four power supplies. Two (6-amp model) or three (10-amp model) fully-isolated input/ control circuits which can be programmed to any output. Two Form C normally-closed trouble relays for AC Trouble and General Trouble, Ground Fault relay available on Canadian models only. 6- or 10-amp full load output, respectively, with 3 A maximum/circuit.Individual NAC power and trouble LEDs for diagnostic efficiency. Trouble history modes for diagnostic support.
Wide range end-of-line supervision value (normal: 2K-27K ohms). Selectable earth fault detection (enable or disable). AC trouble report delay timer. Completely configurable via onboard DIP switches, no extra software required.
Self-contained in compact, locking cabinet constructed of heavy gauge steel with a corrosion-resistant powder coat chip and scratch-resistant finish. Name: Fire-Lite FL-PS Power Supply, Honeywell International, Inc, Fire-Lite. Category: Fire-lite Alarms by Honeywell, Fire, Fire Power & Relays, Fire Power Supplies.
Country of origin: United States. Country of origin is subject to change. This item is in the category "Business & Industrial\Facility Maintenance & Safety\Fire Protection Equipment\Fire Alarms".The seller is "briankturner" and is located in this country: US. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech Republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, Korea, South, Indonesia, Taiwan, South Africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Singapore, Switzerland, Norway, Saudi Arabia, United Arab Emirates, Qatar, Kuwait, Bahrain, Croatia, Republic of, Malaysia, Brazil, Chile, Colombia, Costa Rica, Panama, Trinidad and Tobago, Guatemala, Honduras, Jamaica, Barbados, Bangladesh, Bermuda, Brunei Darussalam, Bolivia, Ecuador, Egypt, French Guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman Islands, Liechtenstein, Sri Lanka, Luxembourg, Monaco, Macau, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Vietnam, Uruguay.